Installing fuel delivery line
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Guide the fuel delivery line (1) in and install.
- Make sure that the rubber damper (2) is positioned correctly.
- Tighten the union nut (3) hand-tight.
- Hand-tighten the bolts (4).
- Tighten down screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Fuel delivery line to cylinder head cover | ||
|---|---|---|
| M6x18 | tightening torque | 7 Nm |
- Tighten union nut (2).
TIGHTENING TORQUE SPECIFICATIONS
| Fuel delivery line to high pressure pump | ||
|---|---|---|
| M14 | Tightening torque | 26 Nm |
- Connect the fuel line (1) to the fuel supply line (5) and lock.
- Ensure that the fuel line (1) audibly engages.
- Ensure that the rubber damper (4) is correctly installed.
- Insert and install the sound insulation (2).
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Feed in and install cover (1).
Follow-up work
- Refer to IF INSTALLED: PARTIALLY INSTALLING ENGINE VENTILATION LINE .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to CONNECTING THE BATTERY EARTH LEAD .