Removing and installing (replacing) left (Xenon) headlight (2016-2022)
WARNING:
Version with xenon lighting system:
Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.
Necessary preliminary work:
- Remove FRONT BUMPER PANEL .
Unlock and remove cover (1).
NOTE:
Work shown on the F20 by way of example, deviations in detail are possible in other models.
Unlock plug connection (1) and disconnect.
Unfasten screws (2).
Tightening torque 63 12 1AZ .
Release screw (3).
Tightening torque 63 12 1AZ .
Release screw (1).
Tightening torque 63 12 1AZ .
Carefully remove headlight (2) in direction of arrow.
Installation note:
Correctly install headlight (1) relative to holder (2).
Replacement:
- Modify XENON CONTROL UNIT .
- Modify ignition unit with bulb. Refer to REPLACING IGNITION UNIT FOR LEFT XENON HEADLIGHT or REPLACING RIGHT IGNITION UNIT FOR RIGHT XENON HEADLIGHT .
- Modify HEADLIGHT DRIVER MODULE .
- Modify LED MODULE DAYTIME DRIVING LIGHTS .
- US version: CHECKING BLOCKING AT HORIZONTAL position