Installing the intake plenum
- Replace gaskets (1) .
Parts: Seals
NOTE:
TECHNICAL INFORMATION
Additional coolant can leakage. Make sure that no coolant enters the intake port of the cylinder head.
Additional coolant can leakage. Make sure that no coolant enters the intake port of the cylinder head.
- Position the intake plenum.
- Tighten screws in the order (1) to (7) .
TIGHTENING TORQUE SPECIFICATIONS
| Intake plenum to cylinder head | ||
| Observe tightening sequence. | Joining torque | 5 Nm |
| Tightening torque | 10 Nm | |
- Tighten down screws (8) .
TIGHTENING TORQUE SPECIFICATIONS
| Intake plenum to rear/front support | |
| BM6x25 | 10 Nm |
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly
Make sure that the connections are locked correctly. The locks must engage audibly
- Lock the closure (2) and connect the coolant return line.
- Lock the closure (1 ) and connect the coolant feed line.
- Clip the wiring harness into the clamp (3) .
- Clip in wiring harness in marked areas.
- Connect the connector (1 ) to the boost pressure sensor.
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Lock closure (2) and connect to the coolant pipe.
- Attach the tank vent line (1 ) in the signaled area.
- Clip in cable (6) in marked areas.
- Position the engine wiring harness and tighten with the screws (5) .
TIGHTENING TORQUE SPECIFICATIONS
| Wiring harness to intake plenum | |
| 5 Nm | |
- Position tank vent line (4) .
- Tighten the screw (3) and clip in the tank vent line (4) in the marked area.
TIGHTENING TORQUE SPECIFICATIONS
| Tank vent line to intake plenum | |
| TS5x 16 | 5 Nm |
- Connect the engine ventilation line (2) to the intake plenum.
- Clip in the tank vent line (1 ) in the marked area.
Follow-up work
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to INSTALLING TENSION STRUT ON SUSPENSION STRUT TOWER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING CIRCUIT .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .