Install heat management module

• Replace the O-Ring (1)  and gasket (2)  .

  Parts:  O-ring and gasket

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean sealing surface (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed out the heat management module (1)  to the outside rear out of the component carrier (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1)  to (3)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Heat management module to engine block
  Captive screws	8 Nm

  Fig 1: Heat Management Module Screws Tightening Sequence

  Courtesy of BMW OF NORTH AMERICA, INC.
• Insert coolant hose onto the heat management module and fasten with the clamp (5)  .

  See that the marking lines up.

  NOTE: TECHNICAL INFORMATION 
  Make sure that the connections are locked correctly. The locks must engage audibly.
• Connect and lock the coolant hoses (3)  and (4)  .
• Clip in positive battery cable in area (2)  .
• Connect connector (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE INTAKE PLENUM .
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to FASTENING CHARGE AIR LINE TO THE THROTTLE BODY .
• Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
• Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
• Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR .
• Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
• Refer to INSTALLING TENSION STRUT ON SUSPENSION STRUT TOWER .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to BLEEDING THE LOW-TEMPERATURE COOLING CIRCUIT .
• Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .