Installing coolant pump with support
- Check the fitting sleeves (1)
for damage, replace if necessary (1)
.NOTE: TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents. - Clean sealing surface (1)
.
- Replace gasket (1)
.
Parts: Gasket
- Replace O-ring on the heat management module.
Parts: O-ring
- Position the coolant pump (2) with support on the fitting sleeves.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Coolant pump with function carrier on crankcase M8 x 35 tightening torque 19 Nm - Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Coolant pump with function carrier on crankcase M8 x 35 tightening torque 19 Nm - Connect vacuum hose (1)
and attach to the clamp.
Follow-up work
- Refer to INSTALLING AIR CONDITIONING COMPRESSOR .
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to CONNECTING THE CONNECTOR WITH THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM) .
- Refer to INSTALLING COVER FOR THE DME CONTROL UNIT .
- Refer to INSTALLING THE ALTERNATOR .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE AIR CONDITIONING .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .