11 14 605 Replacing the crankshaft seal (Transmission side) (Transmission is removed): Notes
Preliminary work:
- Refer to REMOVING FLYWHEEL
- Refer to REMOVING FLYWHEEL
- Refer to REMOVING THE MAGNET WHEEL
Follow-up work:
- Refer to INSTALLING THE MAGNET WHEEL
- Refer to INSTALLING THE FLYWHEEL
- Refer to INSTALLING THE FLYWHEEL
Main work:
Removing the rear crankshaft seal
Remove the magnet wheel (1).
Protect the magnet wheel from shavings with a plastic bag.
The magnet wheel is magnetic.
Provide a vacuum cleaner.
Drill a hole into the crankshaft seal using a 2.5 mm drill (1).
Immediately remove the shavings from the crankshaft seal (1) carefully using a vacuum cleaner.
Screw in the special tool 0 491 454 into the crankshaft seal.
Drive out the crankshaft seal using the special tool 0 491 454 .
Installing the rear crankshaft seal
The radial shaft seal must be installed dry. Do not use motor oil or lubricant.
Install special tool 0 496 137 (11 8 815) on the crankshaft.
Slide off the crankshaft seal over special tool 0 496 137 (11 8 815) so that it is fully in contact with the timing case cover.
Guide the special tool 0 496 137 (11 8 815) out and remove.
Secure special tool 0 494 029 (11 9 182) to the crankshaft using special tool 0 494 031 (11 9 184).
Connect special tool 2 360 215 to special tool 0 494 028 (11 9 181).
Position special tools 0 494 028 (11 9 181) and 2 360 215 and bring into contact with the crankshaft seal in connection with special tool 0 494 030 (11 9 183).
Check the freedom of movement between the special tool 2 360 215 and the crankshaft sensor during installation.
Screw in crankshaft seal until the stop of the special tool 2 360 215 on the timing case cover.