64 53 551 Removing and installing/replacing capacitor (with desiccant insert) for heating and air conditioning system
Special tools required:
- 00 9 030
WARNING:
Danger of injury!
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant oil.
Read and comply with safety information:
Refrigerant circuit is under high pressure!
Avoid contact with refrigerant and refrigerant oil.
Read and comply with safety information:
- Follow safety instructions for HANDLING TETRAFLUORETHANE REFRIGERANT R134A
- Follow safety instructions for HANDLING REFRIGERANT OIL
Attention!
Risk of damage!
Restart engine only when air conditioning has been correctly filled.
Follow instructions for OPENING AND REPLACING PARTS IN REFRIGERANT CIRCUIT .
NOTE:
Desiccant insert cannot be replaced separately.
Necessary preliminary work:
- Drain off AIR CONDITIONING SYSTEM
- Remove RADIATOR
Release screws (1).
Pull out refrigerant lines (2) from condenser (3) and set aside.
Tightening torque 64 53 3AZ .
Release screw (4).
Remove condenser (3) in direction of arrow.
Installation note:
The fins on the radiator and condenser should not be damaged.
Replace sealing rings.
Use special tool 00 9 030 to install sealing rings without damaging them.
After installation:
- Evacuate and fill the HEATING AND AIR CONDITIONING SYSTEM .