64 50... Safety instructions for handling refrigerant oil

WARNING: Injury hazard!
Refrigerant circuit is under high pressure! Work on the refrigerant circuit may only be carried out by experts !
Draw off refrigerant without fail BEFORE all repair work on the refrigerant circuit.
The refrigerant circuit is depressurized AFTER suction!

Before conducting repairs, check the actual pressure drop on the pressure gauge of the A/C service station

Read and comply with the relevant operating instructions for the A/C service station used!

Protective measures/rules of conduct:

Wear safety goggles
Wear oil-resistant hand protection
Do not smoke!
Observe country-specific safety regulations.

First aid measures:

If swallowed: Do NOT induce vomiting, unless expressly instructed to do so by medical personnel. Do not administer anything to an unconscious person through their mouth.
Consult a doctor immediately if larger quantities of this substance are swallowed. Loosen tight-lining items of clothing (e.g. collar, tie, belt or similar).
Eye contact: Remove contact lenses if worn. In the event of eye contact, rinse loops for at least 15 minutes with plenty of water. It is essential to use WARM WATER. Consult a doctor.
Skin contact: In the event of skin contact, rinse immediately with plenty of water. Remove contaminated clothes and shoes. Wash affected clothes before wearing again. Clean shoes thoroughly before reusing. Call for a doctor .
After inhalation: If inhaled, take the person affected outside into fresh air immediately and keep them under supervision. Call for a doctor . If breathing difficulties are experienced, administer additional oxygen. If the person affected stops breathing, administer the kiss of immobilization period.

IMPORTANT: Refrigerant is hygroscopic and must therefore be stored in suitable containers that are sealed airtight!
refrigerant oil is non-flammable and non-explosive at normal temperatures. Nevertheless, the following points must be observed:

Do not store in the vicinity of flames, heat sources or strongly oxidizing materials
Suitable extinguishing agents are carbon dioxide (CO_{) dry extinguishing agent and foam}

Recycling

Catch and dispose of emerging refrigerant oil.

Observe country-specific waste disposal regulations.

Absorb leaked refrigerant oil with fluid-binding material.

Notify the relevant authorities if larger amounts of refrigerant are discharged into aboveground water supplies, drainage systems or subsoil.