Installing the wiring harness section of the transmission wiring harness
NOTE:
RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.
- Route all cables without abrasions, do not trap and crush.
- Guide in the wiring harness section (2) and install.
- Connect and lock the connector for the rotor position sensor.
- Connect and lock the connector for the temperature sensor.
- Connect and lock the connector for the electric oil pump.
- Connect and lock the connector on the sealing sleeve.
The connectors must engage audibly.
- Secure the clamps (arrows).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Wiring harness section for transmission to cylinder head | |
|---|---|
| M6x16 | 8 Nm |
- Guide in the wiring harness section (3) and install.
- Connect connector (1) in direction of arrow and lock.
The connectors (1) must engage audibly.
- Connect and lock the connector (2).
The connectors must engage audibly.
- Insert and install the holder (1).
The holder must engage audibly.
- Connect and lock the connector (1).
The connectors must engage audibly.
- Clip the cover (1) into the holders in the marked areas.
The cover must engage audibly.
Follow-up work
- Refer to INSTALLING PROPELLER SHAFT .
- Refer to INSTALLING THE TRANSMISSION CROSS MEMBER FOR THE TRANSMISSION BEARING .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .