31 35 000 Removing and installing/replacing front stabilizer

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove FRONT ASSEMBLY UNDERSIDE PROTECTION
Remove FRONT V-STRUTS
Remove both STABILIZER LINKS FROM STABILIZER

Unscrew nuts (1).

Tightening torque 31 35 1AZ .

Remove stabilizer; if necessary, press off from engine carrier with a suitable tool.

Installation:

Check RUBBER MOUNT ON BOTH SIDES FOR DAMAGE , replace if necessary.

Replace self-locking nuts.

Fig 1: Identifying Front Stabilizer Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Remove RUBBER MOUNT ON BOTH SIDES FROM STABILIZER .