51 61 011 Removing and installing/replacing V-strut, front axle carrier, left or right
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Driving without V-struts is not permitted!
Driving without V-struts is not permitted!
Necessary preliminary tasks
- Remove FRONT UNDERBODY PROTECTION
Release bolt (1).
Tightening torque 51 71 10AZ x.
Release bolt (2).
Tightening torque 51 71 10AZ .
Release bolt (3).
Tightening torque 51 71 10AZ .
Remove V-strut (4) towards front.
Installation:
Replace bolts.
Make sure bolts are installed in correct positions.
- Bolt (1) M12x30
- Bolt (2) M10x33
- Bolt (3) M10x45