51 47 490 Removing and installing/replacing front underbody protection
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Illustration shows one example only.
There may be differences in detail in the case of other engine variants.
There may be differences in detail in the case of other engine variants.
Release all screws (1) on underbody protection (2).
Remove underbody protection (2).
Installation:
Centre underbody protection (2) and tighten down screws (1).