61 12 062 Replacing wiring harness for front bumper
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES
and cables.
Necessary preliminary tasks
- Remove front bumper trim See 5111156 REMOVING AND INSTALLING FRONT BUMPER TRIM or 5111157 REPLACING FRONT BUMPER TRIM .
Unlock and disconnect plug connections (1) of all four ultrasonic transducers.
Unclip wiring harness (2) from bumper trim (3).
Remove wiring harness (2) from bumper trim (3).
Remove PDC See 6620518 REMOVING AND INSTALLING/REPLACING A FRONT ULTRASONIC TRANSDUCER (SIDE) or 6620520 REMOVING AND INSTALLING/REPLACING A FRONT ULTRASONIC TRANSDUCER (MIDDLE) .
Installation:
Make sure wiring harness (2) is laid correctly.