LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2016 >> Z4 sDrive35is >> Repair and Diagnosis >> External Pages >> Different car >> Section 358 (Rear Axle - Repair) >> 3300 General >> 00...... Raising vehicle with trolley jack

00...... Raising vehicle with trolley jack

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Observe the following trolley-jack-related instructions: 
  1. Use only BMW-distributed/approved trolley jacks which have rubber plate contact points.
  2. Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
  3. Check the rubber plate on the trolley jack prior to each use, replacing if necessary.
Fig 1: Identifying Trolley Jack
G04725307Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: The vehicle may be raised with a trolley jack only at the following jacking points!
  1. Car jacking point
  2. Side car jacking points
  3. Rear differential (REMOVE HEAT SHIELD  )
  4. Risk of damage: It is not permitted to raise the vehicle at the rear differential cover!

  5. Bolting point for rear axle tension struts
Fig 2: Identifying Rear Differential, Side Car Jacking Points And Car Jacking Point
G04747861Courtesy of BMW OF NORTH AMERICA, INC.