Section 312 (Engine Electrical System - Repair (N54))
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- 1200 Troubleshooting
- 61 20... Battery replacement information
- 61 13... Butt connector for repairing a plug connection
- 12 00... Instructions for working on the ignition system
- 12 13 Notes on checking ignition system
- 61 00... Notes on handling wiring harnesses and cables
- 12 00... Notes/information on removing and installing control units
- 12 00... Notes/information on start assistance (jump starting)
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 1212 Ignition Wires, Spark Plugs
- 1213 Ignition Coil
- 1214 Electronic Switching Or Control Units
- 12 14 700 Coding control module (DME/DDE)
- 12 14 705 Programming control unit (DME/DDE)
- 12 14 600 Removing/replacing knock sensors (N54)
- 12 14 550 Replacing control unit (DME) (N54)
- 12 14 521 Replacing crankshaft pulse generator (N54)
- 12 14 524 Replacing pulse generator on exhaust camshaft (N54)
- 12 14 523 Replacing pulse generator on inlet camshaft (N54)
- 12 14 651 Replacing suction pressure sensor on charge-air duct (N54)
- 12 14 650 Replacing suction pressure sensor on intake air manifold (N54)
- 1231 Alternator With Drive And Mounting
- 1232 Regulator
- 1241 Starter With Mounting
- 1242 Starter Lead
- 1251 Engine Wiring Loom
- 1261 Oil Pressure, Oil Temperature, Oil Gauge