12 14 523 Replacing pulse generator on inlet camshaft (N54)

WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks

Read out fault memory of DME control unit
Switch off ignition
REMOVE FAN COWL

Unlock plug (1) and remove.

Release screw.

Tightening torque 13 62 3AZ .

Remove pulse generator (2).

Fig 1: Locating Pulse Generator With Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.