Replacing crankshaft pulse sensor (N55) (X6 xDrive 35i, X6 sDrive 35i)
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove STARTER MOTOR .
Unlock connector (1) and remove.
Release screw (2).
Tightening torque 13 62 6AZ .
Remove connector housing from crankcase.
Release screw (3).
Tightening torque 13 62 7AZ .
Pull pulse sensor from crankcase and remove.
Installation note:
During installation of pulse sensor make sure that guide pin (1) of pulse sensor is inserted in guiding groove (2) of crankcase.
NOTE:
Assemble engine.
Check stored fault message.
Clear diagnostic fault entries from fault memory.
Check stored fault message.
Clear diagnostic fault entries from fault memory.