Installing the oil pressure switch

Guide in and install oil pressure switch (2).
Tighten oil pressure switch (2).
Connect and lock the connector (1).
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the holder (2).
Tighten the screws (1).

G12701591

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE HEAT EXCHANGER FOR THE AUTOMATIC TRANSMISSION .
Refer to INSTALLING THE INTAKE PLENUM .
Refer to INSTALLING CHARGE AIR LINE .
Refer to INSTALLING CLEAN AIR PIPE .
Refer to INSTALLING INTAKE SILENCER HOUSING .
Refer to INSTALLING BOTH COOLANT EXPANSION TANKS .
Refer to INSTALLING CONTROL UNIT HOLDER .
Refer to INSTALLING BATTERY HOUSING (ENGINE COMPARTMENT) .
Refer to INSTALLING AUXILIARY BATTERY (ENGINE COMPARTMENT) .
Refer to INSTALLING CORROSION PROTECTION COVER .
Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE DESIGN COVER .
Refer to CONNECTING THE COOLANT LINE TO THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to CONNECTING THE COOLANT LINE TO THE LOW-TEMPERATURE COOLING SYSTEM .
Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM .
Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM .
Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
Refer to INSTALLING THE UNDERBODY PANELLING ON THE SIDES .
Refer to CHECKING ENGINE OIL LEVEL .