21 52 500 Removing and installing/replacing clutch master cylinder

WARNING: This page is about a different variant/trim than selected.

NOTE: After completing work, bleed CLUTCH HYDRAULIC SYSTEM .

Necessary preliminary work:

Release screws (1).

Take off holder (2).

Fig 1: Identifying Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Undo bolts (1) and (2).

Installation note:

Renew bolts (1) and (2).

Remove clutch master cylinder (3).

Fig 2: Identifying Clutch Master Cylinder And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Detach supply hose (1) from clutch master cylinder.

Fig 3: Identifying Supply Hose And Clutch Master Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Lever clutch switch (1) out of clutch master cylinder (2) with a screwdriver.

Fig 4: Removing Clutch Switch Of Master Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

The clutch switch is secured against incorrect installation.

The clutch switch must snap audibly into place.

Fig 5: Identifying Clutch Switch

Courtesy of BMW OF NORTH AMERICA, INC.