21 00 006 Bleeding clutch hydraulic system (plastic clutch slave cylinder)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work:

Release expanding rivets (1).

Remove cover (2) for cowl panel.

Installation note:

Replace damaged expanding rivets.

Holders (3) must snap into place in suspension cross-brace when cover (2) is installed.

Fig 1: Identifying Cowl Panel Cover And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Connect bleeder unit to brake fluid expansion tank.

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.

Connect vent hose to vent valve (1).

Open vent valve (1) and flush until clear brake fluid emerges without air bubbles.

Close vent valve.

Fig 2: Identifying Vent Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Switch off bleeder unit or remove from brake fluid expansion tank.

Correct brake fluid level in expansion tank.