35 11 000 Removing and installing (replacing) complete bearing support for foot pedal

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After completion of work, perform a functional check.

Necessary preliminary tasks:

Release screws (1).

Remove control units from holder (2). Plugs remain connected.

Fig 1: Identifying Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation note:

Replace self-locking nut.

Tightening torque 35 11 2AZ .

Remove bearing block (2).

Fig 2: Identifying Bearing Block And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1).

Disconnect plug connection (2).

Replacement:

Fig 3: Identifying Plug Connection And Line

Courtesy of BMW OF NORTH AMERICA, INC.