35 11 000 Removing and installing (replacing) complete bearing support for foot pedal

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completion of work, perform a functional check.

Necessary preliminary tasks:

Remove BRAKE BOOSTER

Release screws (1).

Remove control units from holder (2). Plugs remain connected.

Fig 1: Identifying Control Units Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Installation note:

Replace self-locking nut.

Tightening torque 35 11 2AZ .

Remove bearing block (2).

Fig 2: Identifying Bearing Support And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip line (1).

Disconnect plug connection (2).

Replacement:

Modify BRAKE LIGHT SWITCH
Modify holder for control units
Modify CLUTCH PEDAL
In hybrid cars: remount brake pedal travel sensor.

Fig 3: Identifying Plug Connection And Line
Courtesy of BMW OF NORTH AMERICA, INC.