37 12 1090 Removing and installing rear left or right spring strut (M5) (W/Electronic Damper Control)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove REAR WHEEL
Remove WHEEL ARCH PANEL at rear right/left
Remove SPEAKER
Remove BACKREST SIDE SECTION of rear seat on left/right

Release expanding rivet (1).

Disconnect cable connection/connector (2) from EDC damper.

Pull storage shelf (3) outward slightly to be able to pull out the EDC damper cable more easily.

Fig 1: Identifying Expanding Rivet, Plug Connection/Connector And Storage Shelf

Courtesy of BMW OF NORTH AMERICA, INC.

Fold sound insulation (1) aside to reach the screws.

Release screws (2) with ratchet, extension#, 7° flexible spanner head and size 13 hexagon spanner head.

Installation note:

Replace nuts.

Tightening torque 33 52 1AZ .

Fig 2: Identifying Sound Insulation And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 33 52 3AZ .

Remove spring strut from wheel carrier.

Installation note:

Replace screw.

Fig 3: Identifying Left Spring Strut Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Press wheel carrier (1) down.

First move spring strut (2) down slightly in direction of arrow in front of output shaft. Then, at top of wheel arch, swing down spring strut and remove.

Fig 4: Moving Spring Strut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before tightening screw connection, check that spring strut shock absorber pin is correctly positioned in wheel carrier.