32 41 285 Replacing level switch for Dynamic Drive fluid reservoir

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove front left SUSPENSION CROSS-BRACE
Remove intake port for air filter housing. See INTAKE DUCT (N55) or INTAKE DUCT (N63) .

Release screws (1) and (2).

Remove washers.

Tightening torque 32 41 1AZ/2AZ

Remove fluid reservoir by pulling upwards.

Fig 1: Identifying Wheel Arch And Expansion Tank Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Raise and/or turn fluid reservoir in order to gain better access to plug connection.

Disconnect plug connection (1).

Turn level switch (2) through approx. 45° and remove towards bottom.

Fig 2: Identifying Level Switch And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.