32 41 060 Removing and installing (replacing) vane pump for hydraulic steering gear (N55)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When replacing power steering pump:
OIL RESERVOIR must be replaced in event of metal abrasion, sluggish pump shaft or increased wear!
The filter integrated in the oil reservoir can only absorb a limited amount of foreign particles. If the filter clogs, the hydraulic system can no longer be sufficiently protected.
Metal abrasion is perceived in the oil reservoir as metallically glittering hydraulic fluid.
Replacement of the oil reservoir due to a leak (e.g. at the hose connections) is only required with unavoidable high penetrations of dirt.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
DANGER OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with seal plugs.

IMPORTANT: Aluminium screws/bolts must be replaced each time they are released .
Aluminium screws/bolts are permitted with and without color coding (blue).
For reliable identification:
Aluminium screws/bolts are not magnetic.
Jointing torque and angle of rotation must be observed without fail (risk of damage)!

Necessary preliminary tasks

Draw off and dispose of hydraulic fluid from oil reservoir
Remove front UNDERBODY PROTECTION
Remove front stiffening plate (F12 all-wheel drive vehicles)
Remove CHARGE-AIR DUCT
Remove FAN COWL
Remove power steering pump BELT PULLEY

Release hose clamp (1) and detach suction line from power steering pump.

Installation note:

Replace hose clamp.

Align suction line by way of marking (2) to power steering pump connection marking.

Fig 1: Identifying Hose Clamp And Intake Pipe Marking

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screw (2).

Tightening torque 32 41 9AZ .

Installation note:

Replace aluminium screws.

Observe screwing sequence!

Fig 2: Identifying Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 32 41 9AZ .

Installation note:

Replace aluminium screws.

Observe screwing sequence.

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Turn power steering pump to one side, release screw (1) and detach pressure line (2).

Tightening torque 32 41 6AZ .

Lift out power steering pump.

Installation note:

Replace all sealing rings.

Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.

Fig 4: Identifying Pressure Line And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Screw-fastening sequence

Secure power steering pump with screws
Tighten side screw to 2 Nm
Tighten front screws to 2 Nm
Tighten down front screws to jointing torque and angle of rotation
Tightening torque 32 41 9AZ .
Release screw at side and check screw fastening points for gap freedom
Tighten down side screws to jointing torque and angle of rotation
Tightening torque 32 41 9AZ .

After installation

Fill and bleed HYDRAULIC SYSTEM
Check line connections for leaks