52 26 153 Removing and installing/replacing seat cover for left rear seat

Special tools required: 

• 52 0 050

Necessary preliminary tasks 

• Remove REAR SEAT .
• REMOVE OUTER COVER .

Unhook seat cover in marked area.

Fig 1: Identifying Seat Cover Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook spring.

Fig 2: Disconnecting Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Cut open cable tie (1).

Installation: 

Replace defective cable ties.

Unhook spring.

Disconnect retainers in marked area

Remove seat cover with support.

Fig 3: Identifying Cable Tie

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect retainers in marked area

Fig 4: Identifying Retainers Area

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect retainers in marked area

Remove all remnants of clips from cover and support.

Replacement only: 

• Pull all trim wires out of cover
• If necessary, cut pockets in new cover for trim wires
• Push trim wires into cover pockets
  Fig 5: Identifying Retainers Area

  Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert new clamp (2) with special tool 52 0 050 and bend closed.

1. Padding
2. Retainer
3. Trim wire in padding
4. Trim wire in seat cover
5. Seat cover
   Fig 6: Inserting Clamp Using Special Tool (52 0 050)

   Courtesy of BMW OF NORTH AMERICA, INC.