51 47... Removing and installing/replacing damper for screen

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks

Remove SCREEN .

REMOVE BALL SOCKET (1) .

Release circlip (2) and remove pin (3).

Fig 1: Identifying Ball Socket, Circlip And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Feed damper (1) towards front/top.

Fig 2: Feeding Damper

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Bush (1) of lever for screen (2) must not be damaged and must be installed.

Fig 3: Identifying Lever Bush And Screen

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Assemble individual parts of damper unit according to illustration.

Install slide housing from damper unit (1) on screen frame.

Fig 4: Assembling Damper Unit Parts

Courtesy of BMW OF NORTH AMERICA, INC.