51 43 075 Removing and installing/replacing side trim panel, footwell, on A-pillar, right

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT INNER ENTRANCE COVER STRIP
Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT

Detach mucket (1) in area of trim (2). See SEAL ON FRONT DOOR and NOTES ON SEALING INSTALLATION .

Unclip panel (2) in direction of arrow at retaining points (3) and remove.

Fig 1: Removing Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bores.

If necessary, replace faulty clips (1).

Preinstall clip (1) in trim (2).

Fig 2: Identifying Clip On Trim

Courtesy of BMW OF NORTH AMERICA, INC.