51 47 000 Removing and installing/replacing (inside) front left or right door sill cover strip

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Disengage retaining lugs (5) of door sill cover strip (2) from both adjoining panels.

IMPORTANT: Lever out door sill cover strip (2) at front retaining points (3).

Fig 1: Removing Door Sill Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Slide door sill cover strip (2) back approx. 2 cm to feed clips out of rear retaining points (1).

Installation:

If necessary, lever out clips (1) remaining in floor panel and push into clip mounts of door sill cover strip (2).

Replace faulty clips (1).

Clip mountings of door sill cover strip (2) must not be damaged.

Retaining lugs (3) of door sill cover strip (2) must not be damaged.

Fig 2: Identifying Door Sill Cover Strip With Clips And Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.