51 12 157 Replacing rear bumper trim
NOTE:
Pictures created using the X6 3.0 i as an example. There may be differences in detail in the case of other models.
Necessary preliminary tasks:
Necessary preliminary tasks:
- Remove rear bumper trim, see 51 12 223 Removing and installing/replacing trim for rear bottom middle bumper trim .
- Remove rear reflector with rear fog light, see 63 14 120 REMOVING AND INSTALLING/REPLACING REAR REFLECTOR (REAR FOG LIGHT) .
Version with Park Distance Control (PDC):
Remove ultrasonic transducer (1), see REAR LEFT ULTRASONIC TRANSDUCER , REAR RIGHT ULTRASONIC TRANSDUCER , REAR MIDDLE LEFT ULTRASONIC TRANSDUCER , and REAR MIDDLE RIGHT ULTRASONIC TRANSDUCER .
Unclip wiring harness (2).
Installation:
Check wiring harness for damage, replace if necessary.
Make sure wiring harness is correctly seated.
Remove panel from bumper side section (1), see 51 12 210 Removing and installing trim on rear left or right bumper side section .
Remove lower bumper trim section (2), see 51 12 162 Removing and installing/replacing rear bottom middle bumper trim .