51 11 141 Removing and installing/replacing bumper panel at bottom front
Necessary preliminary tasks
- Remove front bumper panel . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM (UP TO 03/2010) or 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM (FROM 03/2010).
Version with Park Distance Control:
Disconnect plug connection (1).
Remove cable from holders (2).
NOTE:
The operation is described on the left side; proceed in the same way for the right side.
Release all latch mechanisms (1) on left and right.
Remove the bottom bumper panel (2).
Installation note:
Latch mechanisms (1) must not be damaged.
Replacement
- Remove BOTTOM MIDDLE GRILLE .
- Remove underride protection.
With Park Distance Control (PDC):
- Remove the ultrasonic sensors.