51 12 050 Removing and installing/replacing support for rear bumper panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove BUMPER PANEL

Depending on version:

Unscrew screws (1).
Unlock and disconnect plug connection on Smart Opener control unit and bumper aerial

Loosen the latch mechanisms (2) at reinforcement (3).

Remove reinforcement (3).

Installation note:

Catches (2) must not be damaged or missing.

Fig 1: Bumper Panel Latch Mechanisms And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, feed out cable.

Unscrew nuts (1).

Tightening torque: 51 12 1AZ .

Remove support (2).

Fig 2: Bumper Panel Support And Nut

Courtesy of BMW OF NORTH AMERICA, INC.