51 11 060 Removing and installing/replacing support for front lower bumper panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front BUMPER PANEL

F20/F21 only:

Remove FRONT UNDERBODY PROTECTION in the working area

Version with air duct:

Unscrew bolts (1) and expanding rivet (2).

Remove air duct (3).

NOTE: Schematic diagram shows the right side. Perform repair work on the left side in the same manner.

Fig 1: Air Duct, Rivet And Bolts

G10096892

Courtesy of BMW OF NORTH AMERICA, INC.

Version with ACC:

Release screws/blind rivet (1).

Installation note:

Blind rivet nuts and associated screws are used as repair solution for defective threads or installed blind rivet.

Adhere to the NOTES on mounting blind rivet nuts.

Fig 2: Blind Rivet

G10096890

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque: 51 11 10AZ .

Remove support (2) in direction of arrow.

Fig 3: Removing Front Lower Bumper Panel Support

G06885313

Courtesy of BMW OF NORTH AMERICA, INC.

In the case of replacement ACC version:

Drill out blind rivets (1).

Modify holder (2) with ACC sensor.

Adjust ACC SENSOR .

Fig 4: ACC Sensor Holder And Rivets

G10096895

Courtesy of BMW OF NORTH AMERICA, INC.