61 33 050 Removing and installing/replacing left fanfare horn

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE front left wheel arch cover
With auxiliary heating equipment specification only:
Remove BUMPER PANEL
Loosen AUXILIARY HEATER WITH BRACKET (do not open the cooling system)

Disconnect plug connection (1) and release nut (2).

Remove fanfare horn (3).

Fig 1: Identifying Fanfare Horn With Plug Connection And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Electromechanical fanfare is installed as standard. The electronic fanfare is only installed in China, India, Russia, South Africa and Gulf states as of 01/2011.

Fig 2: Identifying Electromechanical And Electronic Fanfare

Courtesy of BMW OF NORTH AMERICA, INC.

Electromechanical fanfare
Electronic fanfare

Distinguishing features:

Electromechanical fanfare has a black connector (1)
Electronic fanfare has a white connector (3)
Only the electromechanical fanfare has no adjusting screw (2)
Holder (4) is vehicle-specific and may deviate from the graphic depending on the vehicle.

IMPORTANT: In vehicles with a production data before 01/2011, both fanfares must be replaced in the countries listed above.
The electronic fanfare has a different sound pattern.
Combining the mechanical and electronic fanfares is not permissible.
The connector position may vary slightly.
Pay particular attention to ensuring that the holder is securely seated on the vehicle and that the fanfare is securely seated on the holder! This greatly influences the tone!
If the new part is delivered with a holder included, the part must be replaced complete with holder!