61 12 062 Replacing wiring harness for front bumper
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES
and cables.
Necessary preliminary tasks:
- Remove FRONT BUMPER TRIM .
Disconnect plug connections (1) on five ultrasonic transducers.
Unclip wiring harness (2) from bumper trim.
Remove wiring harness (2).
Remove ultrasonic transducers. See FRONT LEFT ULTRASONIC TRANSDUCER , FRONT RIGHT ULTRASONIC SENSOR , FRONT CENTRE LEFT ULTRASONIC SENSOR , FRONT, CENTRE RIGHT ULTRASONIC TRANSDUCER , and FRONT CENTRE ULTRASONIC SENSOR .
Installation:
Make sure wiring harness (2) is laid correctly.