66 20 517 Removing and installing/replacing a front center left ultrasonic sensor (PDC)
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
Release retaining tabs (2).
Press ultrasonic sensor from outside towards inside and remove.
Unfasten plug connection (2) and disconnect.
Installation note:
Retaining tabs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Before installation of ultrasonic sensor on wiring harness, clean plug connection!
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).