12 41 020 Removing and installing/replacing starter motor (N20, N26)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 BMW 328i xDrive, 2016 BMW 328d xDrive, 2015 BMW 328i xDrive, 2015 BMW 328d xDrive, and 2014 BMW 328i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove INTAKE PLENUM .

Unlock connector (1) and remove.

Release nuts (2) and disconnect positive battery cables.

Tightening torque 12 42 2AZ .

Release screws (3).

Tightening torque 12 41 1AZ .

Feed out starter motor and remove.

Fig 1: Identifying Positive Battery Cables Connector, Nuts, Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check starter pinion and ring gear for damage. Replace starter motor if necessary.

Only during starter replacement and on vehicles with MSA (automatic engine start-stop function):

Use BMW diagnosis system to reset the starter counter.