Gear case cover, cylinders 1-6

Necessary preliminary tasks:

Disconnect plug connection (2 and 4) at solenoid valve.

Unfasten screws (1 and 3).

Release cable duct and lay to one side.

Fig 1: Identifying Connectors And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove both solenoid valves (1 and 2).

Fig 2: Identifying Solenoid Valves

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Release screw (2).

Tightening torque: see 4AZ in 11 14 CASE COVERS

Remove timing case cover (2).

Installation:

Screw (2) required to secure cable duct.

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Check guide sleeves (1) for secure seating and damage.

Installation:

Replace seal (2) .

Fig 4: Identifying Guide Sleeves And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.