LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2012 >> 760Li >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Cooling System - Repair >> Engine Radiator With Attachment >> 17 11 035 Removing and installing/renewing fan cowl with electric fan (N74)

17 11 035 Removing and installing/renewing fan cowl with electric fan (N74)

Necessary preliminary tasks: 

Release lines from fan cowl on clamps (1).

Fig 1: Identifying Fan Cowl Clamps
G08469930Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl.

Release screw (2) on holder for coolant hoses.

Tightening torque: see 5AZ in 17 10 RADIATOR, EXPANSION TANK

Detach coolant hoses with holder from fan cowl.

Fig 2: Removing Coolant Hose Holder Screw
G06889283Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: see 3AZ in 17 10 RADIATOR, EXPANSION TANK

Pull off transmission oil cooler upwards from module carrier.

Fig 3: Identifying Fan Cowl Plug And Screw
G06889284Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at retainers (2) on left and right, feed out in upward direction and remove.

Fig 4: Removing Fan Cowl
G06889285Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert retaining tab (1) at bottom on module carrier.

Fig 5: Identifying Module Carrier Retaining Tab
G04794056Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Check stored fault message.
Reassemble the vehicle.
Delete fault memory.
scientia non olet · About LEMON Manuals