24 34 562 Replacing mechatronics (GA6HP19Z)

WARNING: This page is about a different variant/trim than selected.

NOTE: After completing work:

Load specific data version with DIS.

IMPORTANT: After completion of work, CHECK TRANSMISSION OIL LEVEL .
Use only AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove heat shields.
Support automatic transmission with hydraulic lifter.
Remove TRANSMISSION CROSS-MEMBER .

Brace clamping bush (1) and loosen nut (2).

Detach retainer (3) downwards using a screwdriver.

Pull cable (4) out of holder.

Installation:

ADJUST SELECTOR LEVER .

Fig 1: Identifying Clamping Bush Cable, Retainer With Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Mechatronics can be destroyed by static discharges. Therefore the contacts inside the plug must not be touched. Insert special tool immediately after work step.

Unscrew plug (1) and disconnect.

Fig 2: Disconnecting Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 24 2 390 in sealing sleeve (1).

Fig 3: Inserting Sealing Sleeve Using Special Tool (24 2 390)

Courtesy of BMW OF NORTH AMERICA, INC.

Remove TRANSMISSION OIL SUMP .

Unlock sealing sleeve with slide (1).

Fig 4: Removing Sleeve With Slide

Courtesy of BMW OF NORTH AMERICA, INC.

Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation:

Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!

Fig 5: Pulling Out Sealing Cup

Courtesy of BMW OF NORTH AMERICA, INC.

Release all screws (1 and 2).

1 = M6 x 59 mm
2 = M6 x 20 mm

Remove mechatronics.

Fig 6: Identifying Mechatronics Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check gaskets (1 and 2) for damage, replace gaskets if necessary.

Coat new seals with automatic transmission fluid and install.

Fig 7: Identifying Gaskets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert screws (3) alternately until contact is made with each screw head.

Insert all further screws contact is made with each screw head.

Fig 8: Identifying Screw Head Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: GA6HP19Z TU

IMPORTANT: Tighten down screws in order 1...13.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Tightening torque 24 30 1AZ .

Fig 9: Automatic Transmission Valve Body (Mechatronics) Screws Tightening/Loosening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.