24 11 011 Removing and installing/sealing or replacing transmission sump (GA6HP19Z)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Remove transmission sump only after it has cooled down.
After completion of work, check TRANSMISSION OIL LEVEL .
Use only the approved AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Recycling

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks

Remove rear underbody protection.

Remove oil drain plug (1).

Tightening torque: 24 11 6AZ .

Drain automatic transmission fluid.

Installation:

Replace oil drain plug.

Fig 1: Identifying Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew all bolts.

Remove transmission sump (1).

Installation:

Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque: 24 11 5AZ .

Fig 2: Locating Transmission Sump Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Remove gasket (1) from transmission sump.

Clean sealing faces and groove with a cloth.

Insert new gasket in transmission sump groove.

IMPORTANT: Do not degrease transmission sump with cleaning agent.

Fig 3: Identifying Gasket Of Transmission Sump

Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1) on oil filter tube.

Fig 4: Identifying Sealing Ring On Oil Filter Tube

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

The gasket is correctly installed when it is engaged in the locating opening of the transmission sump.

Fig 5: Identifying Gasket Of Transmission Sump

Courtesy of BMW OF NORTH AMERICA, INC.