24 00 018 Adjusting selector lever (6HP19Z)

WARNING: This page is about a different variant/trim than selected.

NOTE: Check cable for ease of movement.
Move selector lever to "P" position.

Grip clamping sleeve (1).

Loosen nut (2).

Press gearshift lever (3) forwards into park position (P). Press cable (4) in direction of arrow and release again.

Grip clamping sleeve (1).

Tighten nut (2).

Tightening torque, 25 16 2AZ .

Fig 1: Pressing Selector Lever And Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Move selector lever to "P" position.

Check whether parking gear is engaged by turning propeller shaft.