51 46 007 Replacing panel for rear window shelf (parcel shelf)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Specification with tweeter/treble speaker:

Specification with roller sun blind:

Remove trims (1).

Press roller sun blind (2) together at (A) in direction of arrow and press through from (A) to (B).

Remove roller sun blind (2) towards bottom.

Fig 1: Removing Roller Sun Blind Towards Bottom

Courtesy of BMW OF NORTH AMERICA, INC.

Specification with through-loading system:

Release nut (1) on underside of rear window shelf (2) and remove cap (3).

Fig 2: Identifying Nut On Underside Of Rear Window Shelf

Courtesy of BMW OF NORTH AMERICA, INC.

Remove insulating mat in area "A" on underside of new panel (1).

NOTE: Insulating mat is perforated in area "A".

Cut out opening (3) at molding (2).

Drill areas "B" of opening (3) with 8 mm dia. drill bit and cut out remaining material at molding (2) with a scalpel.

IMPORTANT: Ensure a clean cut so that the panel material (1) is not damaged.

Fig 3: Identifying Panel Material, Molding And Molding Cut Out Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Specification with Top Tether eyelets for child seat:

Remove insulating mat in area "A" on underside of new panel (1).

NOTE: Insulating mat is perforated in areas "A".

Cut out opening (3) at molding (2) with a scalpel.

IMPORTANT: Ensure a clean cut so that the panel material (1) is not damaged.

Fig 4: Identifying Panel Material, Molding And Molding Cut Out Opening

Courtesy of BMW OF NORTH AMERICA, INC.