51 46 002 Replacing trim panel for rear window storage shelf (parcel shelf)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Equipment specification with tweeter:

Equipment specification with roller sunblind:

Remove trims (1).

Press roller sunblind (2) together at (A) in direction of arrow and press through from (A) to (B).

Remove roller sunblind (2) towards bottom.

Fig 1: Pressing Roller Sunblind Together

Courtesy of BMW OF NORTH AMERICA, INC.

Equipment specification with through-loading system:

Release nut (1) on underside of rear window storage shelf (2) and remove cap (3).

Fig 2: Identifying Nut, Rear Window Storage Shelf And Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Remove insulating mat in area "A" on underside of new trim panel (1).

NOTE: Insulating mat is perforated in area "A".

Cut out opening (3) at molding (2).

Drill areas "B" of opening (3) with 8 mm dia. drill bit and cut out remaining material at molding (2) with a scalpel.

IMPORTANT: Ensure a clean cut so that the trim panel material (1) is not damaged.

Fig 3: Identifying Trim Panel And Cut Out Opening At Molding

Courtesy of BMW OF NORTH AMERICA, INC.

Equipment specification with Top Tether eyes for child seat:

Remove insulating mat in area "A" on underside of new trim panel (1).

NOTE: Insulating mat is perforated in areas "A".

Cut out opening (3) at molding (2) with a scalpel.

IMPORTANT: Ensure a clean cut so that the trim panel material (1) is not damaged.

Fig 4: Removing Finishing Strip

Courtesy of BMW OF NORTH AMERICA, INC.