51 11 156 Removing and installing front bumper trim: Notes

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Version with headlight washer system:

Release screws (1) on bumper trim (2).

Fig 1: Identifying Screws On Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release screws (1) on wheel arch trim (2).

Lift out wheel arch trim (2) at side.

Installation:

Make sure wheel arch trim (2) is in correct position.

Fig 2: Identifying Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Press wheel arch cover (1) to one side.

Release screws (2).

Fig 3: Identifying Wheel Arch Cover With Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 4: Identifying Screws On Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not damage bumper trim when pulling off.

Detach bumper trim (1) at sides.

Pull bumper trim (1) forwards slightly and if necessary disconnect plug connections on ultrasonic sensors and/or fog lights.

Remove bumper trim (1) towards front with aid of a 2nd person.

Installation:

Height adjustment, refer to BODY GAP DIMENSIONS .

Fig 5: Pulling Bumper Trim Forwards

Courtesy of BMW OF NORTH AMERICA, INC.