33 55 000 Removing and installing / replacing rear stabilizer

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove Stabilizer Link On Both Sides From Stabilizer .

If necessary, remove vibration damper from right retaining bracket of stabilizer.

Tightening torque 33 55 6AZ , see 55 STABILIZER BAR .

Release nuts at both ends.

Remove stabilizer sideways.

Installation:

Check rubber mount on both sides, replace if necessary.

Replace self-locking nuts.

Tightening torque 33 55 3AZ , see 55 STABILIZER BAR .

Fig 1: Locating Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove rubber mount on both sides from stabilizer .