33 55 021 Replacing both rubber mounts for stabilizer mounting
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.
Tightening torque 33 55 6AZ , see 55 STABILIZER BAR .
Release nuts (1) on both sides.
Tightening torque 33 55 3AZ , see 55 STABILIZER BAR .
Turn stabilizer in downwards direction.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.