61 13 040 Replacing distribution box (passenger compartment)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe SAFETY INSTRUCTIONS for handling vehicle battery.
Necessary preliminary tasks:
- Remove LUGGAGE COMPARTMENT TRIM ON SIDE PANEL ON RIGHT
- Disconnect BATTERY NEGATIVE CABLE
- Remove TRIM FOR INSTRUMENT PANEL, BOTTOM LEFT (same as right side)
- Remove RIGHT GLOVEBOX WITH HOUSING
Release screws (1) and remove distribution box (2).
Disconnect all plug connections (1).
Unlock relay base (3) and disconnect.
Open cover (2) on positive battery cable and release nut underneath.
Tightening torque:
- M8: 15 Nm
- M6: 5 Nm
Disconnect positive battery cable from distribution box.
Installation:
Make sure positive battery cable is correctly seated on fuse box.
Replacement:
Remove fuses.