LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1737 (Body Equipment - Repair - E60) >> Instrument Cluster Trim Panel >> 51 45 181 Removing and installing/replacing bottom right trim for instrument panel

51 45 181 Removing and installing/replacing bottom right trim for instrument panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

NOTE: Move front passenger seat completely towards rear.
Drive bottom trim (1) towards rear with special tool 00 9 317  and remove.

Installation: 

Make sure bottom trim (1) is correctly seated at retaining points (2).

Feed bottom trim (1) correctly into bottom right trim for instrument panel (3).

Fig 1: Identifying Bottom Trim And Instrument Panel
G05504040Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT: Carefully remove bottom right trim for instrument panel.

Move bottom right trim for instrument panel (2) slightly forwards and feed out towards rear.

Disconnect plug connection of footwell light (3).

Remove bottom right trim for instrument panel (2).

Fig 2: Identifying Instrument Panel And Footwell Light
G05504041Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Mounts (1) and guides (2) of bottom right trim for instrument panel (3) must not be damaged.

Make sure mounts (1) are correctly seated.

Replacement: