61 35 076 Removing and installing/replacing control unit for backrest width adjustment

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2007 BMW 530xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)

Necessary preliminary tasks:

Remove switch combination for seat adjustment. See SWITCH COMBINATION (FULLY ELECTRIC FRONT SEAT) or SWITCH COMBINATION (SEMI-ELECTRIC FRONT SEAT) .

Unclip cover (1) on front seat.

Fig 1: Identifying Cover

G04742775

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on thigh support.

Disconnect plug connection (2).

Remove thigh support (3) towards top.

Installation:

Insert screws (1) with Loctite.

Fig 2: Identifying Thigh Support, Plug Connection And Screws

G04768245

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim (1) for thigh support carrier.

Fig 3: Unclipping Trim For Thigh Support Carrier

G04792056

Courtesy of BMW OF NORTH AMERICA, INC.

Detach seat cover (1).

Tilt back seat cover (1) with padding towards middle of vehicle.

Fig 4: Identifying Seat Cover

G05478684

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen retainers (1).

Tilt back thigh support (2) towards rear.

Remove all remnants of clips from seat cover and seat mechanism.

Installation:

Bend new retainers closed with pliers 52 0 050 .

Fig 5: Identifying Thigh Support And Retainers

G05478685

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) under tilted-up seat padding.

Unlock plug connections (2) and disconnect.

Remove control unit for backrest width adjustment (3) towards bottom.

Fig 6: Identifying Control Unit, Plug Connections And Screws

G05478686

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .